On reconnection, an address other than the preferred IP address (if specified) may be assigned to the PPPoE connection. To prevent reconnection during working hours, turn on the PPPoE reconnect schedule. When the period expires, the PPPoE connection is closed and reconnected. The IP address assigned to a PPPoE connection, whether dynamic or static (preferred), can have a predefined validity period. It only resets the number of echo request attempts to the default value (3). Note: Clearing the checkbox doesn't turn off LCP. If the firewall doesn't receive a reply from the client after these requests, it disconnects the PPPoE connection. Select this option only if you want to change the default number of echo requests, then enter the value. It only resets the interval to the default value (20 seconds). The firewall sends echo requests at these intervals to check whether the link is live. Select this option only if you want to change the default value, then enter the value. Verify if Sophos Firewall is live through PING on the LAN/DMZ/WAN IP of. The firewall starts only those sessions with the access concentrator that can provide the specified service. Verify that the IP and port through which you are accessing the firewall are correct. The name of the gateway through which you want to route the internet traffic.Īccess concentrator and service name. Sophos Firewall allows you to bind the static IP address to the PPPoE connection.ĭepending on the PPPoE server configuration, an IP address other than the preferred IP address may be assigned to the PPPoE connection. Many internet service providers assign a static IP address to PPPoE connections. Preferred IP address for the PPPoE connection. If you're configuring a PPPoE interface, you must enter the following information as provided by your ISP. If you're setting up a WAN interface, you must also enter the name of your gateway and its IP address. To assign a static IP address to the interface, enter the IP address you want to use and the network's subnet mask. See the next step to set a static IP address for the interface. You must enter the information provided by your ISP. PPPoE connection is normally only used in the WAN zone when setting up a DSL connection to your ISP. If you choose DHCP, no further configuration options are required, and you can save the configuration. Select how the interface IP address will be assigned. When a zone is chosen, further configuration options are shown. Select a zone from the Network zone list. To configure an interface, do as follows: Identify that interface and connect it with your laptop with 172.16.16.x ad make sure the subnet is 255.255.255.0. On fresh installation, first interface (eth 0)of your motherboard will become the internal interface with the IP 172.16.16.16 by default. Your browser doesn’t support copying the link to the clipboard. Answers Oldest Votes Newest AsimMian over 8 years ago Don't get frustrated buddy. It will remain unchanged in future help versions. Always use the following when referencing this page.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |